The carding card clothing is wrapped and rolled and finished
◉The carding card clothing is wrapped until the last side plate edge is about 5mm away;
◉Knock the cowhide, use thin side pressure plate, and wrap the card clothing at a slow speed with the cooperation of the personnel, and use a flat punch when inserting;
◉Start the motor to wrap at a slow speed, and approach the edge strip quickly Stop the car and wrap the roll by hand;
◉ Press the rack with a special small punch and tap gradually with a small hammer;
◉Cut off the excess rack, knock the tail end tightly, and solder it (AB glue can also be used, but pay attention to the length and width of the glue. If the width is too wide, the cotton mesh will be broken and the entrance of the large leakage will be hung. ).
Things to note when using AB glue
◉Using AB glue cannot only bond 1~ 2 places, it is recommended to bond 3 places around the circumference;
◉Use a saw blade to make a small opening on the edge strip at the beginning and end of the card clothing, turn the card clothing back, and tuck it properly .
The reason why the beginning appears after the cylinder is wrapped
◉The distance is not adjusted well, both sides The spacing is inconsistent, resulting in wall-running board flowers, accumulation of flowers between the curved gauges and the cylinder, and cylinder openings;
◉Hard objects enter, squeezing the card clothing, causing openings ;
◉The joint between the two drain bottoms must be flush, otherwise it will easily cause flying flowers and squeeze the card clothing. </p
